USER BENEFITS:

• DEFLECTS UV RAYS 
• BEAUTIFIES
• RUBBERIZED TO WITHSTAND ROOF MOVEMENT
• VERSATILE
• EASY TO APPLY

Top quality Titanium Dioxide pigment gives WHITE ELASTOMERIC ROOF COATING superior reflectivity and exceptional beauty. Damaging ultraviolet rays are deflected before they ever enter and degrade a roof system. This reduces thermal shock which, in turn, preserves the roof membrane and promotes longer service life.

The brilliant white beauty of WHITE ELASTOMERIC ROOF COATING is unequalled. But even more important than simple cosmetic appearance, it protects and preserves the surface to which it is applied. Rubber, polyurethane foam and metal roofs last longer when covered with this product.

WHITE ELASTOMERIC ROOF COATING incorporates special polymers which expand and contract with normal roof movement. These polymers are more UV resistant than conventional SBS types and maintain their flexibility longer under the most extreme weather conditions.

When applying WHITE ELASTOMERIC ROOF COATING, best results are achieved by using a soft-bristled brush, medium-nap roller or airless spray system with a minimum working pressure of 3,000 psi.  Stir thoroughly prior to use. Always apply to a clean, dry surface.
 
 

APLLICATION INSTRUCTIONS   IMPORTANT: DO NOT APPLY WHEN RAIN OR FROST IS FORECAST WITHIN 24 HOURS AFTER APPLICATION!

APPLICATION TEMPERATURE:	50 degrees F. or above
APPLICATION METHOD:	Brush, Roller or Spray
APPLICATION SURFACE:	Must be clean and dry. If wet
	cleaning is necessary, allow
	to dry completely.
PREPARATION AND CURING:	Allow at least 48 hours for
	repairs to cure before coating
	is applied; allow 24 hours
	between coats.
CLEANUP:	Clean tools and equipment
	with soapy water immediately
	after use. Dried film may
	require paint remover.
RUBBER OR FOAM ROOFS:	Apply first coat of WHITE
(Rubber: Do not apply to a rubber	ELASTOMERIC ROOF
surface less than six months old.	COATING at the rate of 1 to
	1½ gallons per 100 sq. ft.
Foam: Sprayed-on roofs that  are	Allow to cure a minimum of
irregular in shape and form may	24 hours.
require more product.)
	Apply second coat at a
	90-degree angle from first
	coat at the rate of 1 to 1½
	gallons per 100 sq. ft.
METAL ROOFS:	Inspect and tighten or replace
	all nails, screws, fasteners,
	etc. and make sure seams are
	secure. New galvanized metal
	should weather for at least
	nine months before coating.
	Apply WHITE ELASTOMERIC
	ROOF COATING to clean dry
	metal in one coat at the rate of
	1½ gallons per 100 sq. ft.
	- OR -
	For better results or if the roof
	has been primed with QUICK-
	DRY ANTI-OXIDENE COATING,
	apply WHITE ELASTOMERIC
	ROOF COATING in two coats at
	the rate of 1 gallon per 100 sq.
	ft. each, allowing 24 hours
	curing time between coats.