USER BENEFITS:

• PROTECTS AND SEALS
• PENETRATES
• ECONOMICAL
• EASY TO USE

The photo above dramatically illustrates the rejuvenating and sealing qualities of QUICK-DRY ASPHALT PAVING SEAL. A piece of ordinary dried out asphalt paving is coated on one half with QUICK-DRY ASPHALT PAVING SEAL while the other half is left as it was on the parking lot. Water poured on the coated side sits on top unable to penetrate and breakdown the paving underneath, while the water quickly penetrates the uncoated side, simulating the effect rain has on a parking lot.

Black-top surfaces deteriorate from exposure to air, sun, rain, freezing weather and snow, from the wear of traffic and from the hardening of the asphalt surface. If this dry, weakened condition is not corrected, cracks and breaks soon appear. Moisture seeps in. The base becomes soft. Traffic churns it up. In low temperatures the moisture freezes and expands, causing unsightly, dangerous holes to develop. Expensive time-consuming replacement becomes necessary.

Virtually eliminates this costly problem quickly, easily, inexpensively by sealing the surface with rejuvenating asphalt. The result is a pliable surface which gives protection and repels damaging moisture to extend the service life of the asphalt paved area.

Many paving sealers on the market coat the black-top surface and are quickly worn off by everyday traffic. This product penetrates deeply into the asphalt surface establishing a tough bond and adding new asphalt life.

Helps avoid expensive, time consuming black-top replacement. Preventive maintenance is quicker, easier and more economical. You save money by applying QUICK-DRY ASPHALT PAVING SEAL the moment voids, hairline cracks, or other small breaks in an asphalt surface are detected. Early repairs help prevent costly repairs from occurring due to neglect. For maximum service from asphalt paved surfaces, apply it BEFORE cracks actually appear to save time, money and the black-top surface.

Newly laid asphalt surfaces should cure at least nine months before applying QUICK-DRY ASPHALT PAVING SEAL to allow for the proper setting up time.
 

Comes ready to use. No heating. No thinning.

STEP 1 - Clean surface to be coated with a stiff brush or broom, or pressure air, removing all sand, gravel and dirt. Grease and oil residue should be removed. If possible, wash and allow surface to dry.

STEP 2 - Agitate by rolling the container on its side a few times.

STEP 3 - Apply as it comes from the container, using brush, squeegee or spray. Application rates should not normally exceed 1½ - 2 gallons per 100 sq. ft.

STEP 4 - Force itinto cracks and voids during application. Do not allow puddles to remain. Remove by brushing material from low areas.

Under normal conditions, the area sealed with QUICK-DRY ASPHALT PAVING SEAL is ready to use in eight hours drying time. A "trial run" may be made after several hours to determine the seal's tackiness and whether the area is ready for normal traffic. Allow extra curing time whenever possible.

Should not be applied to new asphalt pavements (less than nine months) in that softening may occur. Some asphalt pavements are highly absorbent. Test a small area to ensure proper results.
 

GATOR SEAL - a thicker asphalt emulsion designed to fill in and seal aging alligatored areas on black-top surfaces.

CHUCK-HOLE PATCHING MATERIAL - Ideal for repairing small holes and broken areas in black-top or asphalt paved areas. Comes ready to use.