Texas Refinery Corp.
Protective Coatings


"CHUCK-HOLE" 
PATCHING MATERIAL

USER BENEFITS:

  • FOR ASPHALT PAVEMENT REPAIR
  • READY TO USE
  • EASY TO APPLY

    • [Use in Conjunction With One of the TRC Paving Seals, Gator Seal, and Crack Filler for Complete Parking Area Maintenance.]

Chuck-holes can be dangerous and lead to costly damage.

TRC "CHUCK-HOLE" PATCHING MATERIAL quickly and effectively prepares parking areas for traffic.
"CHUCK-HOLE" PATCHING MATERIAL is ideal for the repair of small holes and broken areas in black-top or asphalt-paved areas. "CHUCK-HOLE" PATCHING MATERIAL is easy to apply . . . comes ready to use. It requires no mixing or measuring.

For Asphalt Pavement Repair

Chuck-holes can be dangerous and lead to costly damage. This product quickly and effectively prepares parking areas for traffic.

Ready To Use

It's cold applied. It comes ready to use directly from the container. It requires no mixing or measuring. For best results, during cold weather, keep this container in a warm, dry place for a few days prior to application. Temperature of product should be raised at least to 80°F and used immediately.

Easy To Apply

STEP 1 - Locate and mark all chuck-holes and broken areas. Brush or sweep all dust and loose aggregate from each chuck-hole. Clean each one down to a firm base.

STEP 2 - Paint the chuck-hole sparingly with TRC ASPHALT PAVING SEAL or a suitable Asphalt Primer. DO NOT allow Paving Seal to puddle in the bottom of the hole. Allow the primer to cure a minimum of two hours.

STEP 3 - Fill the chuck-hole heaping full of "CHUCK-HOLE" PATCHING MATERIAL. Tamp it into place with a crown effect - about one-half inch higher in the middle of the chuck-hole than at the edges. "CHUCK-HOLE" PATCHING MATERIAL requires approximately 12 hours setting time, so allow it to set overnight.

It takes approximately one 6 gallon container to fill a volume 3 inches deep and 2 feet in diameter or a hole 3 inches deep, 1.5 feet wide, 2 feet long. 

STEP 4 - TRC ASPHALT PAVING SEAL may be used to seal over repaired areas, only after they have cured to a firm surface for several weeks.
1. Locate and mark all chuck-holes so that none are overlooked when paved.
2. Remove all loose material and aggregate from the chuck-hole. Clean down to firm base.
3. Sweep all dust and loose material from chuck-hole, using stiff brush or broom.
4. Prime the chuck-hole with TRC ASPHALT PAVING SEAL or suitable Asphalt Primer.
5. Apply "CHUCK-HOLE" PATCHING MATERIAL from the container.
6. Tamp Patching Material thoroughly.

Home|Specifications|Prev|Next|Print